Extraction of bituminous coal fly ash for polynuclear aromatic hydrocarbons: evaluation of modified and unmodified supercritical fluid extraction, enhanced fluidity solvents, and accelerated solvent extraction.

Abstract

A comparison among supercritical fluid extraction (SFE), modified SFE, enhanced-fluidity extraction, and accelerated solvent extraction (ASE) techniques was made for the extraction of polynuclear aromatic hydrocarbons (PAHs) from an aged, spiked bituminous coal fly ash. Non-ASE extraction techniques used in this study could not recover PAHs with molecular weights greater than that of pyrene. ASE techniques using methylene chloride (with and without a static step) and toluene were able to recover most of the PAHs studied. None of the ASE techniques could quantitatively extract the low-molecular-weight PAHs from the bituminous fly ash. The medium-molecular-weight PAHs were best recovered with toluene ASE. The high-molecular-weight PAHs were best recovered with the toluene ASE technique (> 80%), but the overall precision of these measurements was low. Methylene chloride ASE with a static step recovered the high-molecular-weight PAHs with the next highest efficiency (approximately 55%) and had standard deviations less than 10% (longer extraction times [> 30 min] with the methylene chloride would increase the recoveries of these analytes.) A comparison of the results from this study with those of a previous study using lignite coal fly ash illustrates the difficulty in developing and adapting analyte-specific extraction methods for analytes that are adsorbed on different matrices.