Abstract
The light-output power of GaN-based light-emitting diodes (LEDs) was enhanced by microhole array pattern and roughened GaO <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">x</sub> film grown on the exposed surface. The GaO <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">x</sub> film was grown by photoelectrochemical (PEC) oxidation via H <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sub> O and formed a naturally rough oxide surface and GaO <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">x</sub> /GaN interface. Compared with that of conventional broad-area LEDs, the output power of the microhole array LED and the surface-oxidized microhole array LED increased by 1.38 and 1.82 times at 20-mA forward current, respectively. The results show that the microhole array pattern with the roughened surface oxide method could significantly enhance light extraction efficiency and be a candidate for manufacturing high-efficient low-cost GaN-based LEDs.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
