Extracting subsurface information from ambient seismic noise — A case study from Germany

Abstract

We analyzed ambient seismic noise from a broadband passive seismic survey acquired in an urban area in Germany. Despite a high level of anthropogenic noise, we observe lateral variations in the quasi-stationary spectra that are of natural origin and indicative of the subsurface in the survey area. The best diagnostic is the ellipticity spectrum which is the spectral ratio of the vertical over the horizontal components. Deviations of the observed spectra from a pure Rayleigh-wave ellipticity allow an approximate separation of surface-wave from body-wave components in the analyzed frequency range, distinguishing shallow (upper tens of meters) from deeper (upper three kilometers) subsurface effects. We observe an increase of vertically polarized body waves between 1 and 4 Hz that is correlated to a subsurface structure that contains an oil reservoir at about 2-km depth. We located the source of the observed body wave microtremor in depth by applying an elastic wavefield back projection and imaging technique. The method includes normalization by the impulse response of the velocity model, effects of the receiver geometry, and lateral variation of incoherent noise. The source region of the low-frequency body wave microtremor is centered above the location of the oil reservoir. Two possible explanations for the deep microtremor are elastic body-wave scattering due to the impedance contrast of the structural trap, and viscoelastic scattering due to poroelastic effects in the partially saturated reservoir.