Extensional flow-induced crystallization of a polyethylene melt

Abstract

Measurements of flow-induced orientation and crystallization have been made on a high-density polyethylene melt (HDPE) undergoing a planar extensional flow in a four-roll mill. The HDPE was suspended as a cylindrical droplet at the flow stagnation point in a linear low density polyethylene (LLDPE) carrier phase. Deformation and crystallization of the HDPE droplet phase were monitored using video imaging in conjunction with measurement of the birefringence and dichroism to quantify the in-situ transformation kinetics. Planar deformation rates along the symmetry axis of the molten HDPE phase were on the order of 0.03 s−1. Measurements of the initial transformation rate following flow cessation at 131.5°C and 133.2°C show a dependence on initial amorphous phase orientation and the total Hencky strain achieved during flow. The flow-induced crystallization rate is enhanced over the quiescent transformation rate by orders of magnitude, however, the dependence on temperature is less dramatic than expected for a nucleation-controlled growth mechanism. Analysis demonstrates that the melting point elevation model cannot account either qualitatively or quantitatively for the phenomena observed, suggesting that alternative explanations for the strong orientation dependence of the transformation rate are needed.