Extending surface-enhanced raman spectroscopy to transition-metal surfaces: carbon monoxide adsorption and electrooxidation on platinum- and palladium-coated gold electrodes

Abstract

Thin (ca. one to three monolayers) films of platinum and palladium electrodeposited on electrochemically roughened gold are observed to yield surface-enhanced Raman (SER) spectra for adsorbed carbon monoxide. The major vibrational band(s) on these surfaces are diagnosed from their frequencies as arising from C-O stretching vibrations, nu/sub CO/ bound to the transition-metal overlayers rather than to residual gold sites. The observed SFR nu/sub CO/ frequencies are closely similar to (within ca. 10 cm/sup -1/ of) those obtained for these systems from potential-difference infrared (PDIR) spectra. The major SERS and PDIR nu/sub CO/ features for the platinum and palladium surfaces appear at 2060-2090 and 1965-1985 cm/sup -1/, respectively, consistent with the presence of terminal and bridging CO on these two electrodes. The infrared as well as electrochemical properties of these systems are closely similar to those for the corresponding polycrystalline bulk electrodes. A difference between the SER- and IR-active adsorbed CO, however, is that the former undergoes electrooxidation on both surfaces at 0.2-0.3 V higher overpotentials than the latter form. Examination of the potential-dependent SERS bands for metal oxide vibrations, nu/sub PtO/, on the platinum surface shows that the electrooxidation potential for the SERS-active adsorbed CO coincides with that for themore » appearance of the nu/sub PtO/ band. Some broader implications to the utilization of SERS for examining transition-metal surfaces are pointed out.« less