Abstract
The gas turbine market tends to drive development toward higher operational and fuel flexibility. In order to meet these requirements, the GT13E2® combustion system (General Electric, Schenectady, NY) with the AEV® burner (General Electric) has been further developed to extend the range of fuels according to GE fuel capabilities. The development includes operation with diluted natural gas, gases with very high C2+ contents up to liquefied petroleum gas on the gaseous fuels side, and nonstandard liquid fuels such as biodiesel and light crude oil (LCO). Results of full scale high pressure single burner combustion test in the test facilities at DLR-Köln are shown to demonstrate these capabilities. With these tests at typical pressure and temperature conditions, safe operation ranges with respect to flame flashback and lean blow out (LBO) were identified. In addition, the recent burner mapping at the DLR in Köln results in emission behavior similar to typical fuels as natural gas and fuel oil #2. It was also possible to achieve low emission levels with liquid fuels with a high fuel bound nitrogen (FBN) content. Based on these results, the GT13E2 gas turbine has demonstrated capability with a high variety of gaseous and liquid fuel at power ranges of 200 MW and above. The fuels can be applied without specific engine adjustments or major hardware changes over a whole range of gas turbine operation including startup and gas turbine (GT) acceleration.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
