Abstract
Increasingly, the laborious task of removing burrs on castings is being automated with the introduction of robots. This is largely to ensure higher level of consistency and efficiency generally not possible with manual fettling. These burrs are unpredictable in size and shape, and if not removed, can lead to major problems in automated factory lines. Fettling is an important area in advanced robotic applications. This paper presents a strategy using a compliant wrist unit to obtain forces during robotic fettling. A specialised fettling wrist unit incorporating a remote centre of compliance (RCC) unit and a CCD camera is described. Experiments are carried out to evaluate the feasibility of this method. Fettling experiments are also performed using a force/torque sensing unit. A comparison of the results of these experiments is provided. The process parameters for fettling are described and relationships among these are established.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.