Abstract
Spray chasing is a specific manifestation of the interaction between split injections, where the mass and heat transfer between the pilot and main sprays significantly influence fuel mixing and ignition processes. In this study, a spray-chasing model is developed and validated based on optical diagnostic results, aiming to theoretically support the development of injection strategies that are more environmentally adaptive and offer improved performance. A series of optical diagnoses of diesel split injection is performed in a constant volume combustion chamber using diffused back-illumination imaging and high-speed schlieren imaging. The extent of the spray-chasing phenomenon is modulated by regulating the injection dwell time (DT) and ambient temperature. For inert sprays, when the background temperature exceeds 790 K, the liquid spray-chasing phenomenon can be disregarded owing to the premature evaporation of the pilot spray. Although shortening the DT can promote the development and mixing of the main spray, the lack of evaporation in the pilot fuel pocket leads to a higher local fuel concentration in the interaction zone after spray chasing, which will hinder the subsequent ignition of the main spray. For reactive sprays, the variations in spray chasing patterns under different operating parameters are determined and their impact on the ignition process is evaluated by combining optical test results with theoretical models. Under cold start conditions, the ignition delay and ignition location of the main spray exhibit a non-monotonic trend with increasing injection dwell time. Optical diagnosis observes that compared to DT of 200 us and 1500 μs, the main spray exhibits both valley in ignition delay time and ignition location at DT = 900 μs. The spray-chasing model identifies approximately 1020 μs as the optimal theoretical DT, expected to best facilitate ignition of the main spray. However, under hot-start conditions, even though the spray-chasing mode varies with different injection dwell times, the ignition characteristics remain essentially unchanged due to the limited promotion effect of split injection on ignition.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.