Experimenting and Optimizing Design Parameters for a Pneumatic Hill-Drop Rapeseed Metering Device

Abstract

The planter plate is the most important component of the pneumatic hill-drop seed metering system for rapeseed. The structural parameters of the planter plate are the primary determinants of rape planting. The key structural and operational parameters, such as the layout of the suction hole, its diameter, and its shape, were determined through theoretical analysis. Fluent is used to simulate the flow field of various types of suction holes, and the effect of suction hole shape on the change in the flow field of the suction chamber shell is analyzed. Under the same boundary conditions, the results indicate that the maximum velocity of the end face of the horn hole and the average pressure of the section are the highest. Using a high-speed camera, the effects of suction hole diameter and shape on seed filling performance were studied, and the results of Fluent simulation analysis were validated. The optimal seed metering device operating parameters were as follows: planter plate speed of 30–70 r/min and negative pressure of −2.5–−1.5 kPa. The influence of working negative pressure and the rotational speed of the planter plate on seed arrangement performance was studied within the optimal operating parameter range. In order to improve the performance of rational close planting in the seed planter, the multi-objective optimization design of working parameters and the verification test were also conducted. The results showed that with the best combination of working parameters, the empty broadcast rate does not go above 3%, the hole number qualified rate does not go below 96%, and the difference between them and the theoretical optimization result does not go above 5.5%.