Experimental verification of the fracture density and shear‐wave splitting relationship using synthetic silica cemented sandstones with a controlled fracture geometry

Abstract

ABSTRACTWe present laboratory ultrasonic measurements of shear‐wave splitting from two synthetic silica cemented sandstones. The manufacturing process, which enabled silica cementation of quartz sand grains, was found to produce realistic sandstones of average porosity 29.7 ± 0.5% and average permeability 29.4 ± 11.3 mD. One sample was made with a regular distribution of aligned, penny‐shaped voids to simulate meso‐scale fractures in reservoir rocks, while the other was left blank. Ultrasonic shear waves were measured with a propagation direction of 90° to the coincident bedding plane and fracture normal. In the water saturated blank sample, shear‐wave splitting, the percentage velocity difference between the fast and slow shear waves, of <0.5% was measured due to the bedding planes (or layering) introduced during sample preparation. In the fractured sample, shear‐wave splitting (corrected for layering anisotropy) of 2.72 ± 0.58% for water, 2.80 ± 0.58% for air and 3.21 ± 0.58% for glycerin saturation at a net pressure of 40 MPa was measured. Analysis of X‐ray CT scan images was used to determine a fracture density of 0.0298 ± 0.077 in the fractured sample. This supports theoretical predictions that shear‐wave splitting (SWS) can be used as a good estimate for fracture density in porous rocks (i.e., SWS = 100εf, where εf is fracture density) regardless of pore fluid type, for wave propagation at 90° to the fracture normal.