Abstract

Inspired by the idea that quantum computers can be useful in advancing basic science, we use a quantum processor to experimentally validate a number of theoretical results in non-equilibrium quantum thermodynamics, that were not (or were very little) corroborated so far. In order to do so, we first put forward a novel method to implement the so called two point measurement scheme, which is at the basis of the study of non-equilibrium energetic exchanges in quantum systems. Like the well-established interferometric method, our method uses an ancillary system, but at variance with it, it provides direct access to the energy exchange statistics, rather than its Fourier transform, thus being extremely more effective. We first experimentally validate our ancilla-assisted two point measurement scheme, and then apply it to i) experimentally verify that fluctuation theorems are robust against projective measurements, a theoretical prediction which was not validated so far, ii) experimentally verify the so called heat engine fluctuation relation, by implementing a SWAP quantum heat engine. iii) experimentally verify that the heat engine fluctuation relation continues to hold in presence of intermediate measurements, by implementing the design at the basis of the so called quantum-measurement-cooling concept. For both engines, we report the measured average heat and work exchanged and single out their operation mode. Our experiments constitute the experimental basis for the understanding of the non-equilibrium energetics of quantum computation and for the implementation of energy management devices on quantum processors.

Highlights

  • With the tremendous and fast advancements of quantum technologies, quantum computers have recently become a reality

  • Inspired by the idea that quantum computers can be useful in advancing basic science, we use a quantum processor to experimentally validate a number of theoretical results in non-equilibrium quantum thermodynamics, that were not corroborated so far

  • In order to do so, we first put forward a novel method to implement the so called two-point measurement scheme, which is at the basis of the study of nonequilibrium energetic exchanges in quantum systems

Read more

Summary

INTRODUCTION

With the tremendous and fast advancements of quantum technologies, quantum computers have recently become a reality. One way to circumvent this problem is to implement a Ramsey-like interferometric scheme where the information on the statistics of energy changes that would be obtained by subtracting the final and initial measurement outcome is encoded in the state of an ancillary qubit [18,19] that is probed only at the end of the protocol One drawback of this method is that it measures the characteristic function G(u), namely the Fourier transform of the wanted statistics, P(W). This engineered projective measurement might not be portable on other quantum platforms Another problem that one typically faces when experimentally addressing quantum thermodynamics results is that normally they are based on the assumption that the quantum systems that are being manipulated and measured are initially in an equilibrium thermal state, while quantum technologies, including quantum processors, typically allow for the initialization of quantum systems in a specific pure state [25]. Well, and characterize the mode of operation of the device as we did for the SWAP engine design

Theory
Experimental validation
ROBUSTNESS OF FLUCTUATION THEOREMS TO INTERMEDIATE PROJECTIVE
HEAT-ENGINE FLUCTUATION RELATION
SWAP quantum heat engine
Quantum measurement cooling
CONCLUSIONS
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call