Abstract
Reference samples, in which artificial discontinuities (defects) are fabricated, are used to verify non-destructive testing procedures. Artificial discontinuities are known defects of reference samples and enable verification the feasibility of the verified NDT method for the identification of location and depth of discontinuities. Thermographic inspection of reference samples also helps to determine the required thermal input source parameters to test samples. This paper presents the results of experimental testing for ultrasonic IR thermography of defects in aramid composite laminate intended for light ballistic armour. Specimens of the aramid composite material included artificial defects and were inspected at various ultrasonic frequencies. Optical thermography and X-ray inspection were carried out on the same specimens, and their results were compared to those determined with ultrasonic IR thermography.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Problems of Mechatronics Armament Aviation Safety Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
