Abstract
The nickel-based superalloy GH4033 is one of the difficult-to-cut materials. In order to investigate the machinability of GH4033, the tool cutting performance, tool failure modes, tool life and the relationships between surface roughness and tool flank wear were studied by using different coated cemented carbide cutting tools under dry cutting. Aiming at the amount of metal removal combining with the tool life and surface quality, the better cutting tool coating type and optimal cutting parameters were obtained through the orthogonal experiments. The results showed that the cutting performance of TiCN coated tool (GC4235) was better than that of TiAlN coated tool (JC450V). With these two kinds of tools, the machined surface roughness decreased to a minimum value and then increased with the increase of flank wear. When cutting GH4033, the main wear mechanism for both of the two types of tools included adhesive wear, diffusive wear, abrasive wear, edge wear and coating peeling.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.