Experimental study on the instability mechanism of the major-defect fractured rock

Abstract

Based on calculations of rock fracture surface and angle, incremental-load creep experiments were conducted on two groups of major-defect fractured rock specimens in an RLW-2000 rheology test system. The research investigated the fracture type and the creep properties of major-defect fractured rock and analyzed the relationships between failure load and horizontal or vertical projection distance, and between each of theme and fracture area or angle. The results showed that rock fracture was divided into three types according to the distribution, including I, II, and III types. I, II, and III types were respectively an internal fracture running through neither the upper nor lower end, one through the upper or lower end and one through both upper and lower ends, and a III type was further sub-divided into IIII and IIIII types. The instantaneous strain was larger than the creep strain under the same creep loading stage. As the creep loading increased on two groups of major-defect fractured rock, the instantaneous strain decreased abruptly and then increased abruptly, while the creep strain decreased rapidly at first and later increased near-linearly. When the failure angle was larger than the friction angle, failure load was positively correlated with failure angle yet was negatively correlated with vertical projection distance. Vertical projection distance and fracture angle, which decided fracture type, controlled rock failure load. Failure load increased in turn from I type to III type, and low-type fracture determined mainly failure load in multiply-fracture specimen.