Experimental study on the flexural behavior of reinforced concrete beam strengthened with novel prefabricated HSSM-UHPC thin plate

Abstract

Listen

Translate article

Ultra-high performance concrete (UHPC) has been used to strengthen reinforced concrete (RC) structures recently. Although UHPC has high compressive strength, the tensile strength is still low and, the high curing condition on site requirements of UHPC may hinder the further application in complex condition. In this study, a novel prefabricated UHPC thin plate, which is reinforced with high-strength steel wire strand meshes (HSSM), is proposed for rapidly strengthening RC beams. In order to understand the flexural performance of RC beams strengthened with the prefabricated HSSM-UHPC thin plate, four-point bending tests were conducted on three beams including one unstrengthened RC control beam (CB), one cast-in-place HSSM-UHPC strengthened beam (SUB) and one prefabricated HSSM-UHPC strengthened beam (PSUB). The failure modes of the beams were investigated and, the crack development process of the test beams was detailly observed by digital image correlation (DIC). Experiment results showed that compared with CB, the cracking, peak load of SUB and PSUB increased by 25.30%, 28.5% and 19.8%, 26.4%, respectively. However, the deflection ductility of the strengthened beams slightly decreased. Finally, calculation model and theoretical equation for predicting the cracking as well as peak flexural capacity of HSSM-UHPC plate strengthened beams were proposed. Comparison between theoretical and test results showed that the proposed model can accurately predict the cracking and peak capacity of the strengthened beams, and can be used for strengthening design.