Abstract
Experimental study on the effect of Reynolds number variation on drag force for various cut angles on D-type cylinders was performed. Five different cut angles on different cylinders were applied including: 35o, 45o, 53o, 60o, and 65o. The free stream velocity was varied so the Reynolds number also varied.The experiment was carried out at a subsonic wind tunnel. Drag force for a cut D-type cylinder (for example 35o) was measured using a force balance and wind speed was varied so that corresponding Reynolds number of 2.4×104÷5.3×104 were achieved. Wind turning angle was kept at 0o (without turning angle). This experiment repeated for other D-type cylinders.Experiment results show that, for all D-type cylinders, drag force decreased as the Reynolds number increased, then it was increased after attain minimum drag force. For all D-type cylinders and all variations of Reynolds number the drag minimum is attained at cut angle of 53o. This value is appropriate with previous experiment results.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
