Abstract
This article presents an experimental investigation into the influence of process parameters viz. feed per tooth, axial depth of cut on milling force, surface finish, wall deflection and micro-hardness during thin-wall machining of an aerospace grade aluminum alloy 2024-T351. Results revealed that the process parameters significantly influence the surface finish and dimensional accuracy of machined thin-walls. High feed rate promoted the formation of built-up-edge (BUE). Combination of high feed and axial depth of cut aided in catastrophic failure of tools. Surface damages such as material plucking, material shearing, material adhesion and deformed feed mark layer formation were observed. Axial depth of cut negatively influenced the wall deflection leading to loss of dimensional accuracy. Interestingly, the micro-hardness at the machined surface was found to be lower than that of the bulk material hardness. These results will be useful in selection of suitable process parameters for quality and precise machining of thin-wall parts.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Materials Forming and Machining Processes
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
