Experimental study on mechanical and damage characteristics of coal under true triaxial cyclic disturbance

Abstract

A true triaxial test system was used to study the mechanical and damage characteristics of coal under tiered cyclic maximum principal stress (σ1), intermediate principal stress (σ2), and minimum principal stress (σ3). The influence of each principal stress cycle on the deformation, energy evolution and damage characteristics of coal was systematically analyzed, and the mechanical evolution characteristics of coal under the disturbance action of true triaxial excavation were revealed. In the process of true triaxial tiered cyclic loading, it is found that: the stress-strain curves of different principal stress cycles processes are quite different, but they will all cause plastic deformation or plastic hysteresis loop of principal strain in each principal stress directions of coal, and the principal strain corresponding to the cyclic principal stress direction is the dominant deformation, and its deformation is relatively large. According to the true triaxial strength curve and experimental results, the cyclic loading or unloading σ2 may cause instability and failure of coal. The variation trend of residual deformation caused by σ1 and σ3 is the same: with the increase of the amplitude of true triaxial tiered cyclic loading, the absolute value of the cumulative maximum and minimum residual principal strains increase exponentially and quadratic parabola, respectively. And the absolute value of the relative maximum and minimum residual principal strains decrease first and then increase, showing U-shaped and arch shaped changes, respectively. While the changes of cumulative and relative residual intermediate principal strains are all small. The total dissipation energy of coal increases exponentially with the increase of the amplitude of true triaxial tiered cyclic loading. Combined with the energy dissipation characteristics, the damage variable equation of coal under true triaxial cyclic loading is newly defined. With the increase of the amplitude of true triaxial tiered cyclic loading, the damage variable presents an obvious S-type change trend of deceleration acceleration re-deceleration.