Abstract

As a new precision processing technology, laser polishing is widely used in metal and non-metal. Laser polishing technology is especially suitable for parts with high hardness and small size. In this paper, a full factor experimental were carried out to investigate the effect of continues wave laser with a wavelength of 1064nm on the surface quality of additive manufacturing Ti6Al4V. The experimental result shows that a smooth surface can be obtained and the average roughness is reduced from 14.95μm to 1.756μm with the reduction rate is as high as 88.3% when laser power is 170W and scan speed is 60mm/s. And the height of the peaks and valleys on the sample surface has also been greatly reduced in condition of the optimized laser processing parameters.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call