Experimental study on fracture damage and seismic performance of loose through-tenon joints in ancient timber structures

Abstract

A looseness is typical damage of mortise-tenon joints in ancient timber structures. Brittle fractures of loose joints are likely to occur, leading to joint failure during earthquakes. This study conducts pseudo-static tests on three groups of full-scaled through-tenon joints to examine the fracture damage and seismic behavior of the loose mortise-tenon joints and determines fracture damage modes of through-tenon joints with different looseness. It uses the acoustic emission method to measure the ring count on the tenon surface, along with each joint's critical load and critical energy release rate and then analyzes the fracture damage performance of different tenon joints. In addition, this research investigates the hysteretic and skeleton curve, stiffness degradation curve, and tenon pulling quantity of the joint under various fracture damage states. The results showed that the fracture failure mode of the through-tenon joint is a fracture in the variable cross-section and along the local tenon neck. During the loading process, the critical energy release rate initially increases and then decreases as the looseness grows. In addition, with the increase of crack mouth opening displacement (CMOD) and crack length, the bending moment of the joint firstly increases and then decreases. When the variable cross-section breaks and the tenon neck partially cracks, the joints' bending moment and stiffness reduce with increasing looseness. With the increase in local embedment compression in the lower side of the beam end and the mortise, the amount of tenon pull-out of loose joints decreases under positive and negative loading.