Experimental Study on Flexible Fiber Assisted Shear Thickening Polishing for Cutting Edge Preparation of Core Drill

Abstract

To improve the cutting performance of the core drill, the flexible fiber assisted shear-thickening polishing (FF-STP) for cutting edge preparation was proposed to eliminate the microscopic defect and obtain proper radius of the cutting edge of the core drill. The flexible fiber was introduced into the shear-thickening polishing process to break the thickened agglomerates and improve the efficiency of cutting edge preparation. The influence of the polishing speed, abrasive concentration and the flexible fiber contact length with the core drill on the cutting edge radius r and surface morphology of the core drill edge was analyzed, and the drilling experiments were carried out after preparation, the cutting heat and drilled holes’ roughness were employed as evaluation indexes to evaluate the performance of the core drill. The results show that the cutting edge radius increases with the increase of polishing speed, abrasive concentration and contact length. However, too high a polishing speed and contact length reduce the abrasive particles involved in the polishing process, and then lead to a decline in preparation efficiency. Under the selected processing conditions, the cutting edge radius increases from the initial 5 μm to 14 μm and 27 μm with 4 min of treatment and 6 min of treatment preparation, respectively. The sharp cutting edge becomes rounded, the burrs and chipping on the cutting edge are eliminated, and the average roughness (Ra) of the flank face decreases from 110.4 ± 10 nm to 8.0 ± 3 nm. Nine holes were drilled consecutively by core drills after cutting edge preparation, and the cutting temperature and drilled holes’ roughness were recorded. The maximum cutting temperature (122.4 °C) in the process with the prepared core drill (radius r = 14 μm) is about 20 °C lower than that with untreated one, and the roughness of the drilled hole (Ra 510.5 nm) about 189.9 nm lower. The results indicates that FF-STP is a promising method for high consistency preparation of the core drill cutting edge.