Experimental Study on Axial Compression Performance of Full-Scale Square Columns of Reinforced Concrete Confined by High-Strength Reinforcement Hoops

Abstract

Axial compression experiments of four full-scale reinforced concrete columns of two groups were carried out. One group of three columns used high-strength steel with the yield strength of 1000MPa as reinforcement hoops, and the second group used the ordinary-strength steel with yield strength of 400MPa. The axial compressive performances between these two groups were assessed. Compared to the specimen using the ordinary-strength steel, the axial compressive bearing capacity of using the high strength steel dose not increase significantly, while the deformation ability increases greatly. The results also indicate that the stress redistributions of the hoops and the concrete sections are obvious, and long-lasting when specimens achieve the ultimate bearing capacity after the yield of the rebar and local damage of concrete materials, at this time the strain of the specimens developes a lot, especially stress - strain curves of speciments with high-strength hoop all show a wide and flat top.