Abstract
ABSTRACTIn this paper, injection molding of squared parts with 1.25 mm in thickness, composed of wood plastic composites (high-density polyethylene, recycled polyethylene terephthalate, and wood flour), was done. The warpage and volumetric shrinkage in the parts was determined experimentally with various process conditions (packing time, melt temperature, wood content, and packing pressure). The experiments were done based on Box–Behnken design of experiments. The significance of each parameter and model was evaluated by analysis of variance (ANOVA). ANOVA showed that packing time and melt temperature are the most significant parameters on warpage and wood content is the most significant on volumetric shrinkage. Packing pressure and wood content had no considerable effect on warpage and packing time on shrinkage too. To obtain optimal process conditions for minimum warpage and shrinkage, a multiobjective optimization based on Pareto front was developed. Response surface method was used to find the relationships between input parameters and objective functions, and genetic algorithm presented the Pareto front solutions to determine the optimum solution. It was observed that there was a good agreement between the predicted optimum values and the experiments.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
