Abstract
The article describes the technique and results of experimental studies of power for driving of a pneumatic screw installation during grain transportation. The instruments and methods for setting and measuring the main parameters are indicated. The equations of regression and graphical dependences of the influence of the speed of the axial air flow, the speed and the pitch of the screw are presented. The values of these parameters are set, at which the power required for the drive has a minimum and maximum value.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
