Abstract
The aim of this work is to study the fundamental Lamb modes interaction with defects in isotropic plates. For these experimental investigations, symmetrical notches with various depths milled in aluminum plates are considered. Moreover, the incident Lamb wave of a specific mode is generated by means of two identical thin piezoceramic transducers placed at the opposite sides of the plate. The waves scattered by the notch are recorded with conventional transducers located on the plate surface in front and behind the defect. The selection of the A 0 or the S 0 modes is obtained by exciting the transducers with anti-phased or in-phased signals, respectively. Furthermore, a calibration process is investigated to correct errors caused by the presence of the receiver between the emitters and the defects. The power reflection and transmission coefficients are then obtained and the power balance is verified. Finally, these measurements are compared successfully with those obtained by a numerical method using the finite-element modeling described in a previous work.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
