Abstract
CVD Co liners are of interest for back end of the line (BEOL) interconnects due to improved Cu interconnect gapfill, especially at narrow feature widths.1-4 The stability of Co liner during downstream BEOL processing is a concern that has been discussed with respect to chemical mechanical planarization (CMP),5-6but its behavior during Cu plating has received less attention. Since Co is less noble than Cu (and its oxide is unstable at low pH), an optimized BEOL metallization process is important to prevent Co liner loss during plated Cu fill. Insufficient Cu seed coverage could expose Co to oxidation and attack in the Cu electrolyte, compromising yield and reliability. In this study, we characterize the anodic dissolution behavior of thin PVD Cu/CVD Co bilayer films using linear sweep amperometry. The thin blanket seed layers are intended to mimic the sparse Cu seed coverage that might be present over a Co liner in a narrow dual damascene geometry. An example of this type of analysis is shown in Figure 1. The top figure (1a) shows the anodic polarization behavior of two separate electrode samples (plotted together), one for thick Co, another for thick Cu. The expected potential difference in the stripping peaks is observed, with Co dissolving at less anodic potentials. The middle (1b) and bottom (1c) figures show the behavior of bilayer electrodes having Cu overlayers of varying thickness. The Cu thickness clearly affects the polarization behavior of the underlying Co, with a fairly thick overlayer required to completely suppress early Co dissolution. The impact of these effects and other Cu chemistry aspects on the interconnect yield and reliability will be discussed. 1. T. Nogami, J. Maniscalco, A. Madan, P. Flaitz, P. DeHaven, C. Parks, L. Tai et al., In Interconnect Technology Conference (IITC), 2010 International, pp. 1-3. IEEE, 2010. 2. H. Shimizu, K. Sakoda, T. Momose, Y. Shimogaki, Japanese Journal of Applied Physics, 51, 05EB02-1 (2012). 3. A. H. Simon, T. Bolom, C. Niu, F. H. Baumann, C-K. Hu, C. Parks, J. Nag et al., In Reliability Physics Symposium (IRPS), 2013 IEEE International, pp. 3F-4. IEEE, 2013. 4. M. He, X. Zhang, T. Nogami, X. Lin, J. Kelly, H. Kim, T. Spooner, D. Edelstein, and L. Zhao, J. Electrochem. Soc., 160, (12) (2013): D3040-D3044. 5. N. Heylen, L. Yunlong, K. Kellens, L. Carbonell, H. Volders, G. Santoro, V. Gravey et al. In Interconnect Technology Conference (IITC), 2010 International, pp. 1-3. IEEE, 2010. 6. K. Tanwar, D. Canaperi, M. Lofaro, W. Tseng, R. Patlolla, C. Penny, and C. Waskiewicz, J. Electrochem. Soc., 160, D3247 (2013). This work was performed by the Research Alliance Teams at various IBM Research and Development facilities. Figure 1
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have