Abstract
Wire cut Electrical-Discharge Machining (WEDM) is a machining process which utilizes a thin wire (around 0.18mm) for material removal. In modern machining of complex object, it plays an important role. Process parameters have great in-fluence on WEDM. MRR, SR and WT are varying process parameters. In this article surface roughness (SR) in WEDM process was analysed using Taguchi method. To validate the results analytical and experimental results were investigated. In experiments it was observed, when peak current value was increased, SR value also increases and in resultant a rough surface was produced. Peak current was observed as most influential parameter with contribution of 82.12%.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
