Abstract
Mould oscillation is needed to reduce friction and thus prevent sticking and breakout of the liquid metal during casting. However, this oscillation is known to cause surface defects in the solidified steel slabs, so called oscillation marks. In this paper, the depth and the depth variation of these oscillation marks were studied using a two-level full factorial experiment (2) with four additional centre point runs. Four factors were studied: stroke length of the mould, oscillation frequency, motion pattern (strip factor) and casting speed. The stroke length affected the depth of the marks the most, where larger strokes created deeper marks. The interaction between the oscillation frequency and the strip factor of the mould also affected the oscillation mark depth. The oscillation mark depth variation was also increased by increased stroke lengths and at higher oscillation frequencies. The largest effect on the oscillation depth variation was found for the interaction between the stroke length and the oscillation frequency.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
