Abstract
This paper presents an oil-filled high-speed spinning process of manufacturing micro-groove fin-inside tubes. In spinning, a high-pressure oil-film, which squeezes the tube outer-wall, is formed as the spinning speed increases. A floating mandrel extrudes the tube inside wall to form the micro-grooves/fins continuously. By experiments of spinning micro-groove fin-inside tubes, this paper analyzes the influences of each process parameter on the formation quality, and optimizes each parameter. The experimental results show that the dynamic pressure can significantly improve the stability of spinning and the quality of finished surface; the minimum thickness of oil-film is decided by the spinning speed and the oil viscosity directly. In the case of full oil dynamic lubrication, there is no obvious scrape on tube surfaces. The main factors affecting the groove depth and the surface roughness are the ratio ( α) of the wall thickness of the tube before drawing to the finished one, the material plasticity, the ratio ( β) of drawing to spinning, the spinning speed ( n), and lubricating state, etc. The axial drawing force mainly depends on the friction between the floating mandrel and the tube internal wall, the friction between the reducing mold and the outer surface, and plastic deformation resistance in the reducing mold area and spinning area as well.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Journal of Machine Tools and Manufacture
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.