Abstract
To study the three-dimensional interfacial structure development in vertical two-phase flow, air–water upflow experiments were performed in a rectangular duct. Various non-uniform two-phase profiles were created by injecting air from individually controlled spargers at the duct inlet into uniformly injected water flow. A four-sensor conductivity probe was used to measure local void fraction, interfacial area concentration, bubble velocity and Sauter mean diameter at three axial locations to record the development of two-phase parameters. Experimental results showed that the lateral development across the wider dimension of the duct was significant with a non-uniform inlet profile when compared to a uniform inlet profile. It is postulated that lift, wall and turbulent forces are the major contributors to the lateral distribution of the two-phase interfacial structures making this an useful experiment for benchmarking three-dimensional two-fluid models. In examining the interfacial area, the shearing-off of group 1 bubbles (defined as the smaller spherical and distorted bubbles) from the skirt region of group 2 bubbles (defined as the bigger cap and churn bubbles), the coalescence of group 2 bubbles due to wake entrainment, and random collision are the major source and sink mechanisms of interfacial area concentration.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
