Abstract
Heat assisted magnetic recording (HAMR) is a promising choice to overcome the superparamagnetic limit in magnetic recording and further increase the areal recoding density of a hard disk drive. However, HAMR brings about serious lubricant depletion problems on the disk surface due to the high temperature in the heat assisted writing process. Experimental studies of the lubricant depletion under HAMR conditions are still very limited so far. It is essential to do experimental studies under real HAMR conditions or under equivalent conditions if a stand-alone laser is used to emulate the HAMR system. In this work, a self-developed HAMR tester is introduced. A method to control the repeatability of laser heating temperature is explained. Lubricant depletion, accumulation, loss, the percentage of accumulation to depletion, and the depth of depletion are determined quantitatively. The effects of laser power, total laser-on-time and laser-off-time in one laser heating and cooling cycle on lubricant depletion are studied experimentally with the HAMR tester. From the experimental studies, it is found that lubricant accumulation at the edge of the lubricant depletion track takes a considerable percentage of the lubricant depletion and the lower the laser heating temperature, the higher the percentage is. Furthermore, media cooling time plays a significant role in lubricant depletion for the media without a heat sink layer and on glass substrate.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
