Abstract
In machining with grinding, it is necessary to know values of geometrical parameters of cutting edges of abrasive grains. In this paper for modeling of cutting edges of abrasive grains with rotation surfaces based on generatrix as a power function and for division cutting edges on both plowing and forming a chip, values of basic parametersBP,NPwere obtained experimentally. The influence of abrasive grain size, sieve-shaking procedure, mechanical properties of workpiece and type of abrasive material on these parameters was determined. The restrictions of this model were designated. It is established that traditional parameters such as corner radiusrand apex angle 2θ can be used in case of microcutting with small grain penetration depth.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.