Experimental Study of As-Cast and Heat-Treated Single-Crystal Ni-Based Superalloy Interface Using TEM.

Abstract

The interface plays an important role in determining strength and toughness in multiphase systems and the accurate measurement of the interface structure in single crystal (SX) Ni-based superalloy is also essential. In this work, the γ and γ' lattice constant, γ/γ' interface width at dendritic and interdendritic region of casting and solution treatment SX Ni-based superalloy is measured. Various advanced equipment is used to characterize γ/γ' interface nanostructure. A typical correlation between interface width and γ/γ' misfit is also summarized. The interface width in the dendritic region of the as-cast sample is larger than that in the interdendritic region. The misfit in the dendritic region is larger than that in the interdendritic region, which has a trend of negative development. There is a common law of the as-cast interdendritic and dendrite interface sample, where the absolute value of the misfit between the two phases is increasing with the phase interface broadening. The comparison of the as-cast and heat-treated interdendritic sample shows that after heat treatment, the phase interface width increases, the misfit decreases, the lattice constant of γ phase increases, and the lattice constant of the γ' phase decreases. By comparing the as-cast and heat treated dendrites, the absolute value of the misfit of the as-cast dendrite sample is significantly smaller than that of the heat-treated sample, and the misfit increases with the interface broadening. The comparison between interdendritic and dendritic heat-treated samples shows that the absolute value of the misfit between the two phases is smaller than that of the dendritic as-cast samples, and the absolute value of the misfit also increases with the phase interface broadening. In conclusion, property heat treatment can significantly increase the lattice constants of the γ and γ' phases, reduce the lattice mismatch at the interface of the two phases, and improve the high temperature stability of the alloy. A better understanding of the microstructure of Ni-based single crystal superalloys will provide guidance for the subsequent design of more advanced nickel-based single-crystal superalloys.