Experimental studies of the geosynthetic anchorage – Effect of geometric parameters and efficiency of anchorages

Abstract

The soil reinforcement by geosynthetic is widely used in civil engineering structures: embankments on compressible soil, slope on stable foundations, embankments on cavities and retaining structures. The stability of these structures specially depends on the efficiency of the anchors holding the geosynthetic sheets. Simple run-out and wrap around anchorages are two most commonly used approaches. In order to improve the available knowledge of the anchorage system behaviour, experimental studies were carried out. This paper focuses on a three-dimensional physical modelling of the geosynthetics behaviour for two types of anchors (simple run-out and wrap around). The pull-out tests were performed with an anchorage bench under laboratory controlled conditions with three types of geosynthetic (two geotextiles and one geogrid) and in the presence of two types of soil (gravel and sand).The results show that there is an optimum length for the upper part of the geosynthetic for the wrap around anchorage.