Abstract

Internal field-emission breakdown in the electrodynamic structures of high-power microwave (HPM) devices can seriously limit the device's output power and pulse duration. Increasing the diameter of the electrodynamic structure to several times an electromagnetic wavelength can reduce these internal fields to below critical breakdown levels, but may introduce mode competition as an unwanted side effect. This paper presents the design and results of experiments with overmoded (D//spl lambda//spl sim/3), sinusoidally corrugated backward-wave oscillators (BWOs) that successfully produced TM/sub 01//sup /spl odot//, high-power microwave radiation in the frequency range of 5.2-5.7 GHz. Overmoded BWOs reproducibly generated /spl sim/200 MW of peak power with corresponding efficiencies of /spl sim/4%. Pulse shortening was not observed in any of the experiments. The radiation generated by the devices was highly coherent (typically, /spl Delta/f/f<0.5%) and corresponded to a fundamental TM/sub 01//sup /spl odot//-mode interaction. The experimental results were compared with calculations made with recently developed nonlinear models; the measured data are shown to agree favorably with theory. The results of the experiments and modeling demonstrate that overmoded electrodynamic structures can be used to decrease internal electric field stresses while avoiding multimode generation and maintaining good spectral purity.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.