Abstract
In 1991, Turchi et al. reported evidence for a 2000 km/s aluminum plasma that originated from the upstream boundary of a wire array armature in a plasma flow switch (PFS). The 2008 article by Turchi et al. posits that if such high $Z$ plasma could instead be composed of deuterium or a deuterium–tritium mixture, then the resultant multi-keV plasma would make an effective target for magnetized plasma compression to fusion conditions. This report documents several experiments executed in an effort to achieve an ultrahigh-speed flow in a deuterium plasma. The first phase of this research concentrated on extension of the earlier work to a lower current system that would emulate the PFS used in series with an imploding liner load. The apparatus was also modified to permit pulsed injection of deuterium gas along the insulated coaxial electrodes between the PFS armature and the vacuum power feed. The experiments met with limited success, exhibiting evidence of a 550 km/s plasma flow which convected a small fraction of the total magnetic field. Two subsequent tests were conducted using foam armatures. In both cases, current prematurely shunted upstream in the vacuum feed. Several possible causes were explored for the shunting of the current. Among the modifications implemented, the gas injection system was altered to increase both the quantity of gas adjacent to the armature while facilitating an increased pressure gradient between the armature and the current feed. A series of low-energy shots were conducted to examine the impact of several proposed design modifications on current delivery to the armature. These experiments demonstrated that the hardware assembled for this investigation was unlikely to forestall breakdown in the injected gas as required by Turchi et al. Nevertheless, two experiments were conducted to evaluate performance with foam armatures. Both experiments exhibited good current delivery to the armature, behaving initially like the low-energy experiments. The magnetic flux convected downstream was greater than in any of the prior experiments, though significant work remains to demonstrate the ultrahigh-speed plasma flow concept.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.