Abstract
Sedimentary nitrogen isotopes have been widely used to reconstruct the nitrogen cycling and redox characteristics of ancient oceans, but they also have important value in the study of oil genesis, such as oil classification. However, the thermal evolution of nitrogen isotopes in the source rock and associated oil is currently unclear. In this study, the thermal evolution (from the oil generation to the dry gas stage) of three types of low-maturity source rock was simulated. And the content and isotope composition of total organic carbon (TOC) and total nitrogen (TN) of the pyrolyzed source rock, expelled oil and retained oil were measured. In combination with weight-quantitative analyses, the following conclusions can be drawn: (1) During the main oil and gas generation stage, the pyrolyzed source rocks lost 15.1–28.3% of TN, which is much lower than the loss of TOC (26.2–46.1%). This difference may be related to the fact that the TOC content of the generated oil and gas is two orders of magnitude higher than the TN. In addition, TOC loss occurred mainly within the oil generation-expulsion stage, whereas TN loss occurred mainly in the dry gas stage and higher maturity stage. (2) The nitrogen isotope compositions of three types of source rocks and associated kerogens became heavier by 0.5–1.5‰ as thermal maturity increased, which is similar to the change of organic carbon isotope compositions. The δ15N values of pyrolyzed source rocks generally have poor relationships with either the amount of expelled oil and gas or the TN loss, which is different from the δ13Corg values. The δ15N fluctuations may be attributed to three processes: oil generation-expulsion, N2 gas generation-expulsion, and inorganic N (like NH4+) expulsion. The bulk nitrogen isotope composition of source rocks is only slightly affected by thermal maturity and can be used to indicate the nitrogen biogeochemical cycle and water redox conditions during the deposition. (3) Similar to δ13Corg values, δ15N values of both expelled oil and retained oil increased gradually with enhanced thermal maturity, implying a control of kinetic isotope effect. Among the three types of source rock, two of them having relatively light nitrogen isotope compositions (δ15N value of ∼2.5‰) generated and expelled oils with similar nitrogen isotope compositions, while the third type, which has heavy nitrogen isotope composition (δ15N value of ∼13.0‰), generated and expelled oils with much lighter nitrogen isotope compositions (by 3–6‰). This finding shows that there may be significant nitrogen isotope fractionation during the generation and primary migration of oil from source rocks. The nitrogen isotopes should be used in oil-source correlation with caution, even though related mechanisms need to be further studied. Nevertheless, using a combination of organic carbon and nitrogen isotopes, the oil generated and expelled by the three types of source rocks could be distinguished. Therefore, the use of nitrogen isotopes for oil-source correlation under geological conditions should be combined with other isotope and molecular indicators.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
