Abstract
The recovery of vegetal waste for energy purposes is one of the ways to increase the amount of energy obtained from renewable sources. The Top-Lit Updraft (TLUD) gasification and combustion process is recognized as the least polluting of all other combustion processes, resulting in a sterile charcoal called biochar, which can be used as an amendment in agricultural soils. The purpose of this research was to determine the influence of excess air in the combustion area compared to the (theoretical) calculated requirement for a TLUD energy module. Most scientific publications on this topic recommend primary/secondary air flow rate ratios of 1/3 or 1/4. In this study, the two recommended ratios were tested, and it was found that better energy results correspond to the ratio of 1/3. For this 1/3 ratio, the investigations continued in order to optimize the combustion process. The results achieved demonstrate that the excess combustion air flow of 30% improves the performance of the energy module due to the increase in oxygen supply and the increase in air speed in the combustion area of the syngas resulting from gasification. Increasing the excess combustion air flow rate by +50% had the effect of lowering the temperature in the flame due to the cooling of the combustion gases caused by a too high rate of excess cold air flow.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.