Experimental Research on the Effect of Particle Parameters on Dynamic Stall Characteristics of the Wind Turbine Airfoil

Abstract

Listen

Translate article

The frequent appearance of sandy and dusty weather in Northwest China impacts the wind turbine. Meanwhile, the non-constant phenomena, dynamic stall speed during the wind turbine operation, will lead to large load fluctuations and unsafe operation. However, few studies have been conducted at home and abroad on the effect of particle parameters on the dynamic stall of airfoils. This paper investigates the impact of particle parameters on the airfoil dynamic stall through numerical simulation of the coupling between the continuous phase and discrete phase by using the SST k-ω turbulence model for a two-dimensional NACA 0012 airfoil. The effect of particle parameters on the airfoil dynamic stall aerodynamic performance, the impact of the flow field around the airfoil, and the particles motion were studied, respectively. The investigation shows a reduction in the aerodynamic performance of the airfoil, due to the addition of particles. The effect is more prominent under a large angle of attack and less under a small angle of attack. When the angle of attack increases, the loss rate of lift coefficient in the windy and sandy environment gradually decreases, while irregular fluctuations emerge when the angle of attack decreases, and the overall rate of change increases more significantly, compared to the stage of the increasing angle of attack. For the particle diameter under 50 μm, the larger the particle diameter, the more significant the change of lift coefficient becomes, as well as the larger the vortex volume near the airfoil’s leading edge, and a large number of particles gather at the suction surface of the airfoil. For the particle diameter of 50 μm, the lift coefficient decreases at any angle of attack of the airfoil movement to the oscillation cycle, the vortex volume decreases, and a large number of particles gather at the pressure surface of the airfoil. However, for particle diameters above 50 μm, the lift coefficient gets reduced, followed by a decrease in the vortex volume near the airfoil leading edge with the increase of particle diameter, so that plenty of particles gather on the pressure surface of that airfoil. At the stage of increasing the airfoil angle of attack, with the increase of particle concentration, there is a gradual decrease of the peak lift coefficient and stall angle of attack of the airfoil, as well as a corresponding decrease of the drag coefficient divergence angle of attack and peak value. In contrast, when the airfoil angle of attack is decreased, the airflow reattachment process obviously lags behind that of the clean air. As the particle concentration increases, the airfoil separation point occurs earlier, and the higher the concentration, the earlier the separation point. The erosion maximum airfoil erosion rate increases with the particle concentration.