Experimental Rat Model of Bony Defects in the Facet Joint Maintained with Bone Wax for the Study of Spinal Pain.

Abstract

PurposeStudies using experimental rat models for low back pain due to facet-joint defects are scarce. This study used a novel experimental rat model to determine whether bony defects induced by facetectomy could be maintained by bone wax, thus mimicking spondylolysis, and to analyze the effect of the facetectomy on rat behavior.Patients and MethodsTwelve 10-week-old male Wistar rats weighing 300–350 g were divided into group A (n = 6) that underwent unilateral facetectomy of the right L5-6 facet joint and group B (n = 6) that additionally applied water-soluble bone wax at the facetectomy site. The difference in the left and right stride length, detected by the footprint test, and change in the left and right facet joint area were compared before and 4 weeks after the experiment.ResultsEven though the difference between the left and right stride lengths of groups A and B was not statistically significant, in contrast to group A, group B showed a shorter stride length on the right side (p = 0.22 and 0.46, in group A and group B, respectively). The right facet joint area, where the facetectomy was performed, was significantly smaller in group B 4 weeks after surgery, but not in group A (p = 0.50 and < 0.01, in group A and group B, respectively).ConclusionBased on the results, we concluded that the bony defects, induced by facetectomy at the L5-6 facet joint, were maintained with bone wax. This study will provide an experimental model for bony defects in the facet joint.