Abstract
Atomizing discharge ablation milling (ADAM) technology is an efficient discharge machining technology derived from the traditional electrical discharge machining (EDM) method, which can be used to efficiently machine hard-to-machine materials such as nickel-based superalloy. In this present, the performance of machining nickel-based superalloy GH4145 by ADAM and Air near-dry EDM were compared, and the experimental results showed that the material removal rate (MRR) obtained by ADAM was nearly double that of the latter. A single-factor experiment were conducted to investigate the effect of electrode rotation speed on ADAM’s processing performance. Subsequently, an orthogonal experimental method was used to design the experiment. The signal-to-noise ratio analysis method was used to systematically study the performance characteristics of ADAM, including the influence of atomization amount, oxygen pressure, discharge current, duty ratio on MRR and tool electrode relative wear rate (TWR). The results showed that discharge current was the most influential processing parameter on MRR and TWR. Finally, the optimal combination of processing process parameters that met the requirements of various processing effect evaluation indicators were obtained and the correctness of the single objective optimization results was verified through experiments.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
