Abstract
PurposeThe purpose of this paper is comparison of experimental values of the drawing forces to numerical values in different contact conditions, taking into account the appearance of galling which occurs due to of difficult drawing process conditions.Design/methodology/approachThe following two research approaches are used in this paper – the physical modeling, realized by the laboratory experiment, and the numerical simulation of the ironing drawing process. By analyzing the obtained results, the technique of physical modeling, with help of the laboratory equipment and numerical simulation by application of the finite element method, can be successfully used in studying the thin sheet ironing – strip drawing process.FindingsIt is significant to compare values of the deformation forces obtained by physical experiment to values obtained by the numerical simulation. In that way, it is possible to compare applied contact conditions (four lubricants in that case) and estimate matching of experimentally and numerically obtained results of the deformation forces. Presented results point out very good technological characteristics of ecologically friendly lubricant (single-bath) and grease based on MoS2. Significant decrease of the deformation force was achieved by its application, as well as maintaining of the lubricant’s layer during the forming process and almost complete elimination of galling on the contact.Practical implicationsNumerical analysis of stresses in the working piece wall, during the thin sheet strip drawing, requires precise values of the friction coefficient. It is an important indicator because one can define the contact conditions as the input data for the numerical simulation, based on its values for each type of lubricants and each value of the compressive lateral force.Originality/valueThe environmentally friendly lubricant tested exhibits a more favorable distribution of the drawing force during the process, mainly in experimental case. Grease based on MoS2 has good lubricating properties but that lubricant is conventional and environmentally unacceptable. Ecologically friendly lubricant can be successfully used in real ironing strip drawing process especially for high values of holding force achieving an increased tool life.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
