Abstract
A procedure has been developed to measure the elastic modulus of small, irregularly shaped specimens without significantly disturbing the specimen's internal or surface structure. This procedure was developed to measure the average elastic modulus of isolated trabeculae from human cancellous bone tissue. The procedure combines direct testing of a cantilever beam-type specimen, along with finite element modeling of the specimen and the testing conditions. Initial estimates for the bone tissue material properties are input into the finite element model; differences between the calculated finite element displacement and the experimentally observed displacement allows the actual material modulus to be determined. Machined aluminum and cortical bone specimens were used to test the accuracy and repeatability of the procedure. Manipulations of the finite element models were performed to examine the effect that mesh construction errors might have on the accuracy of the results. None of the parameters examined resulted in changes in the measured finite element displacements of greater than 8%. In tests on six trabecular bone specimens, an average elastic modulus of 7.8 GPa was calculated. Even taking into account the possible sources of error, this value remains significantly less than the accepted value for cortical bone.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of orthopaedic research : official publication of the Orthopaedic Research Society
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
