Abstract
Stress gradients were experimentally measured in a 316 stainless steel sheet after bending with a press brake. Two different tool radii and three different bend angles were used to produce plastically bent sheets. Microhardness tests were performed across the thickness of the bent sheet, and a correlation between microhardness and strength was experimentally determined and was used to obtain the stress gradient. The position of the experimentally determined neutral plane correlated well with theory. Theoretical calculations of the stress gradient were made using a power law constitutive equation along with a simple mechanics analysis of plastic bending. Four of the six bending experimental conditions had reasonable correlation with the theoretical calculations. Ideas for improving this experimental method are discussed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.