Experimental Investigation to the Properties of Eutectic Salts by NaCl-KCl-ZnCl2 for Application as High Temperature Heat Transfer Fluids

Abstract

A group of eutectic ternary halide salts were surveyed and studied for the objective of developing a high temperature heat transfer fluid with a freezing point below 250°C and a low vapor pressure, below 1.0 atm, at temperatures up to 800°C. The studied salts include: 1) NaCl-KCl-ZnCl2 with a mole fractions of 18.6%-21.9%-59.5% and a melting point of tm=213°C; 2) NaCl-KCl-ZnCl2 with a mole fraction of 13.4%-33.7%-52.9% and a melting point of tm=204°C; and 3) NaCl-KCl-ZnCl2 with mole fraction of 13.8%-41.9%-44.3% and a melting point of tm=229 °C. Vapor pressures of these salts at different temperatures were experimentally obtained using an in-house developed test facility. The results show that vapor pressures of all the three eutectic molten salts are below 1.0 atm at a temperature of 800 °C. The salt of ZnCl2-KCl-NaCl in mole faction of 44.3%-41.9%-13.8% has lowest vapor pressure which is only about 1.0 atm even at a temperature of 900 °C. Viscosities of these salts were measured in the temperature range from after melting to 850°C. At low temperatures near their melting points of the salts, the viscosities are about 16 × 10−3Pa s, while at high temperatures above 700°C the viscosities are around 4 × 10−3Pa s, which is satisfactorily low to serve as heat transfer fluid for circulation in a CSP system. Both the vapor pressure and the viscosities of the studied three eutectic salts demonstrated satisfaction to serve as high temperature heat transfer fluids. Other thermal and transport properties of these salts are expected to be reported in the future for screening out a satisfactory high temperature heat transfer fluid.