Abstract
ABSTRACT It is well known that the replacement of round tubes to oval tubes in a fin-and-tube heat exchanger reduces the air-side pressure drop as well as the low-performance region behind the tube, which improves the thermal performance of the heat exchanger. However, experimental evidences are lacking, especially for generic heat exchangers. In this study, generic heat exchangers having oval tubes were tested, which included two different oval tube dimension and two different tube pitches. Round tube samples were also tested for a comparison purpose. The effect of fin pitch on j factor was negligible, whereas f factor increased as the fin pitch increased. Furthermore, both the j and f factor decreased as the number of tube row increased. A thermal performance comparison based on the ratio of thermal conductance per unit volume () to pressure drop per unit length () revealed that the oval tube samples yielded a higher performance than the round tube samples, except at a small number of tube row. Furthermore, the best performance was obtained from the oval tube samples having a smaller diameter tube. On the other hand, relatively poor performance was obtained from the oval tube samples having a larger diameter tube, probably due to the large pressure drops. The j and f correlations were developed based on the data.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.