Abstract
This paper investigates the effect of graphene nano platelet (GNP) content (%weight fraction) on the machinability of epoxy/GNP nanocomposites. The machinability of nanocomposites with varying loadings of GNP content was evaluated experimentally through the characterisation of cutting forces, surface morphology, chip morphology and tool wear. The minimum chip thickness phenomena of epoxy/GNP occurred at feed per tooth (FPT) between 0.2 and 0.4 μm. In order to achieve to better surface quality, the FPT should be over 0.4 μm. Epoxy/GNP with 1.0 wt% nanocomposite has produced the highest cutting force of a feed rate of ~ 3 N at 12 μm/rev. Epoxy/GNP nanocomposites exhibit the different cracking tendencies compared with plain epoxy, and the tool wear for GNP/epoxy nanocomposites is very small compared with metal nanocomposites. There is no significant difference in slot width accuracy between different types of tools, such as uncoated tool, diamond-like carbon-coated and diamond-coated tools.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: The International Journal of Advanced Manufacturing Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
