Abstract
Particulate reinforced titanium matrix composites (PTMCs) are attracting increasingly attention in various engineering applications. In this paper, comparative grinding experiments of PTMCs were carried out using WA abrasive wheel and CBN abrasive wheel. The morphology of the ground surface was observed by scanning electron microscope. The main results are summarized as follows: (1) The damage of reinforcements in the PTMCs results from the plowing and shearing during grinding in the form of crater, micron gap, broken, coating and micron crack. (2) The formation of grinding chip is a function of the collaborate removal of reinforcements and matrix material. (3) The surface fracture pattern of PTMCs using WA wheel is to form the grinding chip through severe extrusion. While using CBN wheel, the abrasion due to the formation of the wear debris is the main surface fracture pattern of PTMCs.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.