Experimental investigation on foam formation through deformable porous media

Abstract

AbstractFoam formation in porous media is a topic of growing scientific and industrial interest due to its range of applications, from daily life consumer products to oil recovery. Despite the work done so far on foams flowing through complex structures, such as rigid porous media, this subject still needs to be fully elucidated. An additional complexity to the problem arises when the porous medium is deformable, a situation which has only been faced, to our knowledge, from a modelling point of view. In this work, the investigation of foam formation in deformable porous media is carried out by using commercial sponges as a deformable porous media system, with special emphasis on the effect of confinement on foam bubble size distribution. Foam is formed by wetting the sponge with an aqueous surfactant solution and then squeezing the sponge either between two glass cover slides or between a plastic net and a cover slide. Our experimental data reveal that the latter system allows the formation of drier foams (ie, with lower liquid fraction, fL < 0.3), more similar to the ones obtained in dish‐washing applications. Moreover, the effect of sponge type, in terms of material and microstructure, on final foam is presented. Our results are of potential interest for the optimization of foams in complex structures, such as in deformable porous media.