Experimental investigation on effective aerosol scavenging using different spray configurations with pre-injection of water mist for Fukushima Daiichi decommissioning

Abstract

During the decommissioning of the Fukushima Daiichi nuclear power plant, it is important to consider the retrieval of resolidified debris both in air and underwater configurations. For the subsequent retrieval of debris from the reactor building, the resolidified debris must be cut into smaller pieces using various cutting methods. During the cutting process, aerosol particles are expected to be generated at the submicron scale. It has been noted that such aerosols sizing within the Greenfield gap (0.1–1 μm) are difficult to remove effectively using traditional spraying methods. Therefore, to improve the aerosol removal efficiency of the spray system, a new aerosol agglomeration method was recently proposed, which involves injecting water mist to enlarge the sizes of the aerosol particles before removing them using water sprays. In this study, a series of experiments were performed to clarify the proper spray configurations for effective aerosol scavenging and to improve the performance of the water mist. The experimental results showed that the spray flow rate and droplet characteristics are important factors for the aerosol-scavenging efficiency and performance of the water mist. The results obtained from this study will be helpful for the optimization of the spray system design for effective aerosol scavenging during the decommissioning of the Fukushima Daiichi plant.